Leaderboard

Before fitting the top, I have to cut the slot for the fretboard, and before I can do that I have to cut the taper, and before I can do that, I have to slot the fretboard as, in my jig, that is a LOT easier if you are starting with parallel sides. So slotting the fretboard was next job. I use another G&W tool - their fretting mitre jig: In ebony, it is pretty hard work, but over the day all were done. Then I could both taper the board and also add a couple of mother of pearl swifts at the 12th before I fret it. I tapered the board and marked in pencil where I would eventually need to 'intercept' the ebony top: The swifts are pencilled freehand onto the sliver of mother of pearl and cut out using a jewellers saw. I then pencil round the inlays onto the ebony and carefully route out to the inlays depth using the precision base for my Dremel with a 1mm bit. I double check that they fit and then I will fill the chambers with epoxy mixed with ebony sanding dust and firmly press the inlays in. And finish with a final sand with the radius block As always, thanks for looking!

I cut the top ebony around the pencilled line of the fretboard end which allowed me to lay the fretboard on the angled neck and position the top. I drilled a couple of positioning holes in the middle of the pickup positions which, with the addition a couple of kebab sticks will stop the top from floating around as it's being clamped when the glue is applied: That meant I could check that the neck angle is going to be correct for the height of a standard tune-o-matic roller bridge: And so what about the end of the fretboard that is hanging in mid air? Well, of course the offcut from the neck blank when I cut the neck angle in the first place is going to be the correct angle. So I will be able to cut a short ramp from this (ignore the odd shaped headstock in the background - that's not connected with this project ) I will also be adding a demarcation stripe of maple between the alder and ebony: And so, with the kebab sticks positioning everything until the clamps were all on and then removed before the glue set, the clamps can now go on! :